Oxygen concentrator

K2008 Oxygen concentrator

Operation Instructions

Contents

1)Before using

Safety precautions

Principle of operation

Names of parts

2)How to operate

How to use

3)When required

How to maintain

Daily maintenance

Specifications

Safety precautions

In order to prevent the risk of danger to the operator of this product or those nearby, and damaging property, be sure to follow the safety precautions outlined below.

? The following terms are used for precautions. They are separated depending on the degree of the danger or damage that may occur if their contents are ignored while using this product.

This term cautions you that injury or physical damage to property may result may result by incorrect operation of the product.

This term warms you that death or serious injury may result by incorrect operation of the product.

The following signs are used to explain operations that you are requested to follow. They are separated as shown below. (Below are examples of the signs used in this manual.)

This sign designates actions that you must never do (prohibited actions).

This sign designates actions that you must do (required actions).

NOTE

Do not the components with the air of an electric dryer, etc. (It may cause deformation or failure.)

1.Reassemble the components.

NOTE

* Be sure to mount the filter before use.

Mounting the O2 mouthpiece

The orientation (front or back) is not an issue for the filter.

Specifications

Daily maintenance

CAUTION

Maintenance required when odor and dirt become annoying or after a long period of disuse.

Maitenance on O2 headset and tube set

1. Remove the capsule and tube.(Leave the capsule and tube mounted except when performing maintenance.)

2. Remove the mouthpeiece, filter, and the mouthpiece cap.

Removing the O2 mouthpiece

Pull out the mouthpiece slowly the direction shown by the arrow.

Daily maintenance

3. Rinse the coponents. * Soak the coponents in water for 2 to 3 minutes and let water go thorugh the tube.

NOTE

Do not soak the components in water that is hotter than 60? (Otherwise, it causedeformation or discoloring.)

Do not rinse the whole O2 headset.

Do not use detergent, benzene, thinner, or alcohol.(Otherwise, it may cause deformation or disclolring.)

Be careful not to lose the filter, which are small.

4. Dry the coponents

1) Wipe out and drain off the moisture.

2) Mount the components on the unit as shown in thefigure on the fight and operate for 30 minutes to dry out the unit.

3)Remou the O2 headset, capsule and tube and dry them copletely in a celan place in direct sunlight.(If drying is incoplete, water may drip out of the O2 mouthpiece during operation.)

CAUTION